Occurs at absolute ceiling where low speed buffet and high speed (Mach) buffet are coincident.

When reaching the coffin corner, both increasing and decreasing the corner speed will result in a loss of control (either the aircraft stalls, or mach buffeting starts).

The elevation at which the airplane departed from the runway.

Because of the distance which has to be covered to reach 41.000 feet which may not be convenient for a short flight.

On long flights it is more typical to fly at 41.000 feet when the aircraft weight and performance allows.

TORA= Takeoff Run Available, the length of runway declared available and suitable for the ground run of an aeroplane taking off.

TODA= Takeoff Distance Available, the length of the take off run available (TORA) plus the length of the clearway, if available.

ASDA= Accelerated Stop Distance Available, the length of the takeoff run plus the length of the stopway, if available.

A clearway is an area beyond the paved runway, free of obstructions and under the control of the airport authorities. The length of the clearway may be included in the length of the takeoff distance available (Take Off Distance Available (TODA)). For example, if a paved runway is 2000 m long and there are 400 m of clearway beyond the end of the runway, the takeoff distance available is 2400 m long.

The stopway is an area beyond the runway which can be used for deceleration in the event of a rejected takeoff.

Screen height: TODR is the distance from the brake release point to the point where the aircraft gains a height of 35 ft above the ground. This 35 ft is what we call the screen height. While 35 ft is the screen height for class A airplanes, it is 50 ft for class B airplanes.

On a wet runway, the screen height is reduced to 15 ft.

The FMA indicates what system is controlling the aircraft and what mode is operational.

New York to London (flying east) would take less time because of the Polar front westerly jet stream.

No. Carburetor heat uses exhaust air to heat air going into the carburetor. No electrics are involved.

This speed is defined to be equal to the greater of stall speed (Vso) multiplied by 1.3, or stall speed (Vs1g) multiplied by 1.23.

The landing configuration that is to be taken into consideration can be defined by either the operator or by the aeroplane manufacturer but is most commonly assigned by the manufacturer.

A turbofan is a type of jet engine, similar to a turbojet.

It essentially consists of a ducted fan with a smaller diameter turbojet engine mounted behind it that powers the fan.

Part of the airstream from the ducted fan passes through the turbojet where it is burnt to power the fan, but the majority of the flow bypasses it, and produces most of the thrust. They are mainly used commercially because they are highly efficient and relatively quiet in operation.

1.98°C per 1000ft